Installation Instructions
CE-601
The CE-601 is a three-phase regulator designed to fit all
2001 and later Softails.
Remove Old Regulator
1) Disconnect battery
negative terminal.
2) Disconnect regulator DC
wire
3) Disconnect ground wire.
Note: if you tie a piece of fishing line to the ring
terminal of old regulator wire before pulling wire out. You can use this cord
to pull the new wire in place.
3) Take note of how old wire
is routed. Cut wire ties and remove wire.
4) Unbolt regulator and remove.
Install New Regulator
1) Mount new regulator.
2) Route DC+ output wire to
the silver post on the main circuit breaker
3) Connect AC plug to stator,
on rubber mount models keep wires away from front motor mount. It moves and can
damage wires.
4) Check the routing of all
wires to be sure they are not in a vulnerable position. Keep wires away from
exhaust pipes and moving parts. Be sure wires are not in the very bottom of
lower frame or they will get pinched if you bottom out.
Replace all wire ties previously cut and add new ones
where necessary.
5) Reconnect battery and
start motor. Test battery voltage. All “L” model regulators should run between
13.7~14.1 Standard models should run 14.2 to 14.6 depending on what model you
have.
Have A Good Ride!!